Part:2 ITR Front & Rear Sway bars???

Springs, Struts, Swaybars, Bushings, Tower Braces & more
 Reply
User avatar

By JLau
- Thu Apr 03, 2008 7:36 am #48980 You need to make sure that you have all brackets and bushings.

For the front you'll need either the EX/Si front lower control arms or Integra ones because the DX and I believe CX models LCA's do not have the mounting holes.

The same goes for the rears except you need Integra rear LCA's for the mounting holes. You also need a set of 4 nuts and 4 bolts to mount the bushing brackets to the subframe right above the bolts that mount the rear LCA's to the subframe.
User avatar

By Graham
- Thu Apr 03, 2008 2:52 pm #49010 Is it not the wishbones you need? I thought the ARB mounted to the wishbone, the lca is the same im sure for every Civic and Integra - mine came off an eg6 and were the exact same as my eg4 ones (i have no ARBs :( )
User avatar

By LowTEC-Derbo
- Thu Apr 03, 2008 4:46 pm #49029 you need the lower arms for the front and rear that have sway bar endlink mounts.


ITR/GSR front sway bars uses different endlinks than the typical LS/GS/RS and EX sway bars.


The rear will require some sort of subframe brace as the ITR rear sway uses a flat surface unlike the other rear sway bars which are almost half the size.

Beaks, BSQ, or ASR, or Comptech have pieces to mount the ITR on a flat surface without replacing the rear subframe with an ITR one.
 Reply
Return to EG Chassis Suspension