Civic EG

Posted: **Fri Sep 09, 2011 12:47 pm**

So I recently received my Koni Yellows and tried to install them on my car, but unfortunately my current coilovers didnt fit! So I decided to go with the H&R Race springs but I still face a problem, the tophats I have wont slide onto to damn Koni's

So my question for you guys is this, what tophats should I look into getting for my setup to work/should i just drill the one I have out a little bit? All second opinions would be greatly appreciated!

ps, i already looked into the GC tophats but they only work with the Koni/GC Combo.

:thumb:

Posted: **Fri Sep 09, 2011 5:23 pm**

Posted: **Fri Sep 09, 2011 5:28 pm**

Are the Konis for your specific car? Most all Integras, CRX, Civics (EF-EK) use the same top hats, so that leads me to believe that maybe the Konis arent for a Civic, maybe they're for another vehicle.

Posted: **Fri Sep 09, 2011 5:40 pm**

they are for my year civic

Posted: **Sat Sep 10, 2011 1:59 pm**

Posted: **Sun Sep 11, 2011 4:24 am**

If they are for your vehicle as you state, then I would take something like a file and slowly enlarge the opening until the strut fits through.

Posted: **Wed Sep 14, 2011 12:39 am**

lol thats what i was thinking about only dif is i was going to drill that bitch :twisted:

Posted: **Wed Sep 14, 2011 1:52 am**

Sounds like a plan :thumb:

Posted: **Tue Sep 20, 2011 11:07 pm**

been doing some research online and it would appear as though this is a relatively common problem. Time to borrow a drill I guess

Posted: **Wed Sep 21, 2011 1:02 am**

Get one on the cheap from a pawn shop!

Civic EG

H&R/Koni Yellow Combo

H&R/Koni Yellow Combo