Civic-EG.com Forum 3.3.1

- Sun Jun 15, 2008 10:05 pm #58642 ok so today i got new front calipers and installed them. after i bled the front brakes and it seemed fine until i was completely done and started to drive, the pedal goes down alot further then it used to, it also comes very close to the floor, and sometimes it did but still stopping the car. what do i do? i also have rear drums if that matters. thanks

- Sun Jun 15, 2008 10:09 pm #58644 you are suppose to bleed the entire system. that means front AND rear.

-LowTEC Derbo "the coupe" Build Thread
http://civic-eg.com/viewtopic.php?t=1589
272whp 214wtq

- Sun Jun 15, 2008 11:53 pm #58651 UPDATE bled all four brakes twice and still goes lower than normal and slowly drifts down. please help.

- Mon Jun 16, 2008 9:24 pm #58781 is it possible to bleed the master cylinder on the car? need to know asap. thanks

- Mon Jun 16, 2008 10:48 pm #58786 sounds to me your master cylinder might be going out. Your master cylinder isnt able to hold the pedal properly..

-LowTEC Derbo "the coupe" Build Thread
http://civic-eg.com/viewtopic.php?t=1589
272whp 214wtq

- Mon Jun 16, 2008 11:33 pm #58791 but thats what i dont understand, it was working fine, then i replaced the calipers, i put new ones on and now its doing it! its so frustrating! i tried loosening the brake lines to the master cylinder until no air bubbles came out then bled all the brakes and it still does it.