- Wed Jul 23, 2008 8:33 pm
#63119
I know this is a Civic forum... but not everyone owns a civic :p this could also be used as a guide as well if ya wanted, and can also be applied for 94-97 integras as well (looks at DC4rob) lol
1) Remove Headlight, i'm going to assume that you have the knowledge of how to do this already
2) preheat oven to 200f. bake headlight for 5-7 minutes.
3) remove lens from healight, this is done by prying it.
4) take the FX projector and remove the lens.
5) place 300zx len's on projector and reattach the lens holder
6)remove factory headlight assembly from headlight
7) remove the rear part of the factory projector, and the factory lens
aparently mine was broken
get the trusty hacksaw and cut off the factory projector front
9) mount up the FX projector, drill holes in the projector and the factory mount, then bolt the projector to the to the housing
10) make sure it's all aligned up. then put the headlight back together, I placed it in the oven for 4 minutes to allow the factory glue to soften up. so the lens goes on better. I then sealed it up so it wouldn't fog, use waht ever method you would like for this. Since the integra headlight is covered by the bumper i just used weatherproof all purpose tape..
11) put the headlight back in and enjoy
before)
After)
Here's a comparison from the 5000k Kit, and the retro
Passenger headlight only w/ kit
Drivers only w/ retro
Remember when Civics were cool ? Yea me neither
1) Remove Headlight, i'm going to assume that you have the knowledge of how to do this already
2) preheat oven to 200f. bake headlight for 5-7 minutes.
3) remove lens from healight, this is done by prying it.
4) take the FX projector and remove the lens.
5) place 300zx len's on projector and reattach the lens holder
6)remove factory headlight assembly from headlight
7) remove the rear part of the factory projector, and the factory lens
aparently mine was broken
get the trusty hacksaw and cut off the factory projector front
9) mount up the FX projector, drill holes in the projector and the factory mount, then bolt the projector to the to the housing
10) make sure it's all aligned up. then put the headlight back together, I placed it in the oven for 4 minutes to allow the factory glue to soften up. so the lens goes on better. I then sealed it up so it wouldn't fog, use waht ever method you would like for this. Since the integra headlight is covered by the bumper i just used weatherproof all purpose tape..
11) put the headlight back in and enjoy
before)
After)
Here's a comparison from the 5000k Kit, and the retro
Passenger headlight only w/ kit
Drivers only w/ retro
Remember when Civics were cool ? Yea me neither
