Page 1 of 1

How is this panel attached?

PostPosted: Sat Apr 23, 2011 12:08 pm
by ZactheRipper
Image

Not my car BTW. I had a little fender bender in a carpark and this panel is bent in a little, quite lucky since this seems to be the only damage.

But i cant figure out how this panel attaches to the rest of the car so i can figure out how to pull it back out, any help guys?

Thanks.

PostPosted: Sat Apr 23, 2011 12:22 pm
by 95c1v1c
There are 2 access holes under the rear light, they are very tricky because you can drop the nuts down in there if you aren't careful.

PostPosted: Sat Apr 23, 2011 10:27 pm
by Flatland_EG
Just in case, you might want to pick up one of those magnetic retrieval tools, shouldn't cost more than a couple bucks. :thumb:

PostPosted: Sun Apr 24, 2011 4:13 pm
by Ajax1989
95c1v1c wrote:There are 2 access holes under the rear light, they are very tricky because you can drop the nuts down in there if you aren't careful.


this and there 10mm
and becareful to dont drop the bolts
but if u do there only 10mm bolts with washers
thats wat like a dollar or 2 at the hardware store