Civic EG

Hey Folks,

Sorry if this is a repost in advance, or a question that's already been answered.

So here's the deal, I have about 2 inches of water in my rear passenger tail light (outter one) and i really need to empty and reseal my light so that it doesn't burn out.

I've literally looked everywhere on how to remove the light and I already know there are two screws that are totally hidden. I do know that i have to remove/pull back some of the plastics to get to these two screws.

I just dont know where to start.

Does anyone have pics or is anyone able to post pics so that I can see where to begin?

Thanks!

(i'll also post pics so that you guys can see how much water my light has. Everytime it rains here in Vancouver I get about a half an inch of water back there.)

Hey folks, so here is the crazy amount of water pooling in the back of my tail light.

Sorry in advance for the sizing!!

its held in with 4 8mm bolts, two near the trunk lip and two kinda recessed near the quarter panel, use a flash light and you should be able to see em