Civic EG

Posted: **Fri Dec 11, 2009 6:24 pm**

does any 1 know wut i have to modify and also andy additional parts i would need to put in an s2000 ep3 fit or 06 and above civic steering wheel in my cx hatch

Posted: **Fri Dec 11, 2009 6:39 pm**

I'd like to actually know if this could be done.

Posted: **Thu Feb 11, 2010 6:28 pm**

anyone with info on how to do this ???

Posted: **Fri Feb 12, 2010 9:54 am**

From what i have heard none will fit without custom fabrication.
Get a dc2 wheel as they go straight on.

Posted: **Fri Feb 12, 2010 4:07 pm**

i found this on club civic

http://www.clubcivic.com/board/showthread.php?t=182091

it looks really good.

Posted: **Fri Feb 12, 2010 5:34 pm**

do you plan on doing this saadi?? if so make sure to post up some photos

Posted: **Fri Feb 12, 2010 5:43 pm**

that would not work. ek9 (96-00) spline is very different.
Actually if you look at the nrg website, their hubs come for eg/dc and ek9/ep3/s2k. this means that s2k and ek9 splines are same, while eg is different and only shares spline with DC brethrens.
Hope this helps!

Posted: **Mon Feb 15, 2010 12:43 am**

I want to have one of the steering wheels that can be taken off, similar to the race car-ish steering wheels. Just a thought.

Posted: **Mon Feb 15, 2010 12:52 am**

yeah you would have to swap out the steering column from an ek or dc, theres no fabrication you just swap them out. i know this cus i asked the same question before about an ep3 steering wheel

hope this helps :thumb: