Civic-EG.com Forum 3.3.1

- Sun Jul 03, 2011 1:40 am #262030 I bought my 93 eg hatch about 3 months ago. Just recently my car had a hard time starting, like it slowly starts. I thought I had to charge my battery, so today I charged it then tried starting it again. But it just gets slower and slower, then it just makes these clicking sounds then it doesn't start. I really don't know what to do and need help. Thanks.

[teal_dx]

- Sun Jul 03, 2011 2:32 am #262038 Sounds like it's time for a new battery.

Do Not PM me your technical questions. Post them in the forum!
My 1992 SOHC Turbo Hatch
My Youtube Channel: 6th Gear Garage

- Sun Jul 03, 2011 2:52 am #262041

Sounds like it's time for a new battery.

x2,you can take the car to a near autozone or advanced and they will test the battery for free

http://civic-eg.com/viewtopic.php?t=17990 <--- my bubble build

- Sun Jul 03, 2011 8:13 am #262080 Alright thanks guys. Imma have the batteries checked.

- Sat Jul 09, 2011 3:39 am #262917 so the battery is alright. they said it could be the starter.

- Sat Jul 09, 2011 4:00 am #262922 my 4door did this about 3 months ago. threw a starter in it and was good to go. advance tried telling me my starter was fine when i had them test it, i had to point out to them that their test does not test it with a load on it. lol it was time 4 a starter anyway oem had 256k miles on it. put in a starter and you should be good.

- Sat Jul 09, 2011 4:23 am #262925 check your cables and ground wires if they are corroded they can pull alot of votage , resistance is one bad mofo

also check to make sure your terminals are not lose , idk how many time i have a a loose negitive terminal , also they starter wire shouldnt have any play

hope this helps

94 eh9 sedan d16z6
R TISTIC

- Mon Jul 11, 2011 2:21 pm #263164 U can replace the starter or replace the copper contacts in your current starter...its a simple fix

- Wed Jul 13, 2011 6:50 am #263425

U can replace the starter or replace the copper contacts in your current starter...its a simple fix

ill try look that up.

- Thu Jul 14, 2011 7:11 am #263553 I had the same problem couple of months ago, the coal brushes were worn out.

Replaces them and it was all fine again.

My Build Thread