Civic EG

would the teggy type-r lump be harder to install in a dx than say a vti? if so what can be done and do i need anything extra?

peace

im guessing your a UK member?

putting a b18c type-r lump into a VTI is pretty simple... all the gear linkage is the same, drive shafts are the same, VTI loom can be used - just needs to be slightly modded and an ecu conversion harness.

putting a b18c type-r lump into the 1.3dx is ablot harder but in a sense it will be faster because the dx model is uber light weight.

but... it will be alot more expensive to do and alot more time consuming.

you will need to change pretty much everything!

engine, gearbox, drive shafts, loom, ecu, gear linkage, brakes, fuel tank, fuel lines...

HTH

yeah thats all good i got lots of time y0

and yes im from UK

cheers for the help

np mate - you could just buy my car?

thats too easy mste an di luv my civic to much

also im only 17

yo i own a dx

i would do a motor swap

but i have to upgrade my weak ass dx brakes and fuel lines 1st

discs all round were the first mod i did ...

my mum shelled out for it so i would be safe

drums on rear will be fine

just get vti fronts or even better 282s for street use

no i mean ive already got discs all round

lucky u

i found 262mm hubs and 240mm hub at scrappy
was gunna get em the next day but some 1 took the drivers side hub

unlucky u

well chin up and keep lookin i guess

17 and you wanna drop a b18 in there ?

no not yet 1 or 2 years mate but u cant plan to much