Civic-EG.com Forum 3.3.1

- Sun Feb 22, 2009 7:48 am #98121 So I have a coupe and its missing the side molding that goes from the fender, to the door an to the rear panel.
My question is this,
HOW DO YOU TAKE THEM OFF ANOTHER CIVIC WITH OUT DAMAGING THE MOLDING, or THE CLIPS???

- Sun Feb 22, 2009 1:33 pm #98155 you have to take them off from the inside

I <3 my Honda.
>Two.Zero< Garrett 60-1
~587whp-384wtq~ pump/meth tuned by BTperformance
@cdmtyper

My Build Thread
http://civic-eg.com/viewtopic.php?t=718

- Mon Feb 23, 2009 3:52 am #98328 yeah just use some needle nose pliers and go at it from the inside of the car. Not sure hard. I removed the one that was on my other coupes passenger door cause the one that was on this coupes door was really messed up.

- Mon Feb 23, 2009 4:01 am #98335 I generally just break the clips taking the molding off then buy new clips, big hand make it hard to take the clips out from the inside

- Wed Feb 25, 2009 4:51 pm #98929 LUCKILY I HAVE SMALL HANDS YAAAAAAAAAAAAAAAAAY