General tranny info covering all models & motors.
User avatar
By openshot
#184272 hello i am planing on making somthing cool for my civic. where a shifter boot is not needed. kind of like this.

Image

i am looking for the outline for the civic something i can print off and use that to cut out with.
User avatar
By Classiccarsrule85
#184275 Boy i thought of that one awhile back for my old BMW it dosent work too well unless your shifter has a stiff shiftlike with the energy suspension bushings and well event with that it dosent make for a nice clean shift or look....and you would have to make it out of a thick guage steel as if you hit the tabs they could bend making it impossibly to shift into that gear....
User avatar
By openshot
#184281 i will be making it out of plastic
User avatar
By 3kkl3sia
#184289
openshot wrote:i will be making it out of plastic


props if you can do it, but not only will it most likely look jerry-rigged it, like john said would be extreamly hard to find a template to find the tranny shift points and getting it accurate enough to actually get into gear. but good luck
User avatar
By openshot
#184304 i will be using clear plastic for the finshed one
User avatar
By slowj1
#184328 I think there is very little side to side movement in the shifters... and if its a short throw shifter the back and forth motion is decreased even more. I honestly dont know if it can be done but more power to ya if you get it to work
User avatar
By TrailerTrash
#184352 I would make sure you go tthe energy suspension bushings AND a short shifter to minimize the play in the shifter.

good luck and keep us posted I hope you can pull it off
User avatar
By forcefedEG
#184353
TrailerTrash wrote:I would make sure you go tthe energy suspension bushings AND a short shifter to minimize the play in the shifter.

good luck and keep us posted I hope you can pull it off


x2 good luck