Civic EG

Hey guys, yesterday i dropped my tranny and installed a new clutch and flywheel...i made sure i did everything properly when installing and putting the tranny back on the car...the problem is that when the car is off all the gears will go in, but once the car is turned on i can't get any of the gears to go in at all...do you think i need to bleed the clutch?

Adjust the clutch pedal.

how do you adjust a clutch on a hyrdo tranny?

anyway... i would start by bleeding the clutch reservoir and lines, with a new clutch, the engage point will be towards the floor a lot more than a worn out unit. Assuming you didn't mess anything up, bleed the lines, does the clutch just seem like it doesn't work?