Civic EG

Just some helpful info!! As seen on Teal's hatch, the stainless russell braided line going directly from Clutch Master to Slave cylinder. want a clean install at the CMC, you need these parts from Earl's performance for your honda!!.

Save you the headache of looking!!! the thread holes in the CMC and slave cylinder are -3AN females!!!!!!!!

-3AN male to -3AN male 90 degree fitting
EAR-982103ERL

http://www.summitracing.com/parts/EAR-982103ERL/

and you need to connect to this.

-3AN female to -3AN female 90 degree elbow..
EAR-935103ERL

http://www.summitracing.com/parts/EAR-935103ERL/

I want to thank Teal for the Help!! after waiting a while for a rep and explaining what i needed. they pointed me to the right direction!!

Good info!
I'm gonna move this to the transmission section since it's about the clutch lines.

thanks teal! no problem!!! and again!! thanks for your help!!!!!!