Civic EG

So i went to change my transmission fluid today and this is what i find...faaack









any ideas on getting these bad boys out would be awesome guys, the nuts are completely rusted to the washers too, when i get these off where can i grab new ones/what are the specs on them

pb blaster patience and a good 6pnt socket and good socket wrench

Get some Skunk2 or PWJDM or MFactory or whatever Magnetic drain plugs, the fill plug will have to be either from a dealer or a junkyard or wherever you can find it.

Since the trans case is aluminum, they should just spin right out, but just to be safe, hit it with PB for a few hours. Tap the bolts with a hammer or mallet while spraying them.

they will come out. they are tick enought. 3/8 breaker bar. that one will come out with no issue. the fill might strip a bit. but should come off . did you try to take em off yet or didnt even bother. Get new ones at the dealer...

honestly could not get them off and didn't have any pb blaster or lube at the house, i tried tapping the socket with a hammer too to try and loosen it and nothing, i was cranking my ass off trying to get them out but not even a budge