tranny swap help. in a ek
Posted: Wed Jan 05, 2011 11:44 pmWell i bought a automatic 6 gen civic an i was wondering if my shift linkage, tranny mount, axles will work. And also if i do have to mess with wiring when i do? Thanks for any help.
Civic EG
Forum for the Honda Civic EG 1992-1995
http://www.civic-eg.com/forum/
tranny swap help. in a ek
Page 1 of 1
Posted: Wed Jan 05, 2011 11:44 pmPosted: Fri Jan 07, 2011 12:16 amBump
Posted: Fri Jan 07, 2011 4:12 amwhat shift linkage, tranny mount, axles do you have? From an EG? The mount is different, I'm 99% sure the shift linkage should be the same (unless its from a del sol), and the axles are the same. you can even reuse the auto tranny axles because all the d series manual and auto axles are the same.
For wiring, just wire up your reverse lights and clutch switch - all the same as a 92-95 manual swap
For wiring, just wire up your reverse lights and clutch switch - all the same as a 92-95 manual swap
Posted: Fri Jan 07, 2011 5:39 amShift Linkage are different, the EG/DC Ones will be longer. Delsols way to long. Ek Linkage is about 2 inches shorter. You can put Eg Linkage into a Ek and drive it however 4th gear is where 3rd would be and 3rd is almost touching the center console.
You will need EK Shiftlinkage, Mounts(passenger and rear "T")The rest of your stuff on the Ek you should be able to reuse.
You will need EK Shiftlinkage, Mounts(passenger and rear "T")The rest of your stuff on the Ek you should be able to reuse.
Posted: Fri Jan 07, 2011 10:32 pmThanks guys. So far this helped me a lot.