Page 1 of 1

i need a bit of help with this one...

PostPosted: Sun Feb 20, 2011 4:12 am
by slow_learner456
getting ready to start pulling a tranny to do a clutch for a friend of mine who has a 92 integra.

heres the story,

hes broke as hell and doesnt have much money for starters.

his integra is a 92.

i found a clutch on good ol' craigslist that says its for an 90-91 integra for 30 bux. its new and i guess the guy is sick of looking at it. its one of those ebay stage one deals. and seeing as the car is just a daily driven get to work car as long as it works its good i figured it doesnt matter who made it.

but my question is will this work in the 92 integra.

i poked around on autozone.com and the part number for the clutch kit for a 90 is the same as a 92. but when i look up the disk alone the part numbers dont match...

im a little confused and need some guidance one this one if someone can help. thank you guys in advanced.

PostPosted: Sun Feb 20, 2011 4:24 am
by 94EJ2
if the full kit has the same part number it should work

PostPosted: Sun Feb 20, 2011 6:06 am
by JUICE
i KNOW there are two types of B series cable clutches and they are NOT interchangeable..

PostPosted: Sun Feb 20, 2011 5:59 pm
by slow_learner456
hmmm.. i was not aware there was. im assuming that the change occured in 92 with the incorperation of obd1.

silly variations in things that otherwise shoulndt have them :x

thanks for helping me clear this up./