Civic EG

i noticed my clutch wasnt working to well

the pedal would go to the floor
i read in a older post that the master cylinder could be leaking or the slave
so i walk out to my car and the master cyl. inside the firewall is totally soaked...

so i take it i need to replace that

i found one for like 80 bucks...

wat do i need to do to replace it

you just need i think a 10mm socket and the wierd brake line nut tool looseners so you dont strip anything and i think youll have to bench bleed it as well but im not totally sure i know it is easiy to take out but getting to it is another story....

what he said
just buy a cheap set of line wrenchs

Classiccarsrule85 wrote:you just need i think a 10mm socket and the wierd brake line nut tool looseners so you dont strip anything and i think youll have to bench bleed it as well but im not totally sure i know it is easiy to take out but getting to it is another story....

this sucks
i totoally didnt want to spend my saturday fixing my car...

well once i disconnect it from my pedal i can just slide it out through the engine compartment?

alright
thank you guys for the help.
i bought the master and installed it
after bleeding the system and fillin it with clean fluid again it works great

=] its like learning to drive agian though cuz my clutch engages alot further out
i think its been leaking fluid since i bought the car...