Page 1 of 1
New custom harness bar! Let me know what you think...
Posted:
Fri Mar 01, 2013 2:35 amby JG_motorsports28
Just made this today. Got the seat from a friend and scored 2 sets of harnesses for cheap. The metal cost $22 for the bar and that's it!
Posted:
Fri Mar 01, 2013 2:41 amby Fada Blayne
was just looking at these online, nice job.
Posted:
Fri Mar 01, 2013 1:59 pmby Civic_HatchSI
Looks good
Posted:
Sat Mar 02, 2013 7:11 amby bigpunn421
what do these do?
i always thought b pillar bars we dangerous? most harness bars without a roll cage are dangerous
Posted:
Sat Mar 02, 2013 4:55 pmby JG_motorsports28
It gives you a proper place to mount the harnesses. The need to be mounted level or no more these 10 degrees down from level so you don't compress your spine. I'm sure some aren't safe but I trust mine 100%. It's 1" 120 wall so it's not going to bend plus the v brace welded to the ground stiffens it up and holds it solid
Posted:
Sat Mar 02, 2013 11:30 pmby bigpunn421
if you ever have a roll over which i hope no one ever does you will likley be killed or seriously injured. i know first hand people who wish they never made that mistake
http://forums.bimmerforums.com/forum/sh ... ?t=1824442
i just dont see why people spend all this money to skimp out on safety.
safety should be more important
Posted:
Sun Mar 03, 2013 2:52 amby JG_motorsports28
That's an eBay harness bar for sure. The ones that mount to all four seatbelt points have 0 rigidity. I'm so tall if my car rolls I'm screwed anyway but my harness bar will not budge