Page 1 of 1
integra interior in civic
Posted:
Sun Feb 03, 2008 5:49 amby perez_tamayo
will dash and door panels from an integra sedan fit on a civic sedan?
Posted:
Sun Feb 03, 2008 7:09 amby chrono404
The Dash fits, I have scene it done a few times. However there is probably alot of Fabing needed to have it done right. Not sure about Door panels though.
If it did that would be killer, it would look very awesome.
Posted:
Sun Feb 03, 2008 7:20 amby asianrob
i seen people do the door panels before they said it fits fine but then again they say the EG panels will fit fine just they have a small gap
Posted:
Sun Feb 03, 2008 7:20 amby LowTEC-Derbo
rear 4door integra seats fit the civic sedan.
Posted:
Sun Feb 03, 2008 7:24 amby asianrob
LowTEC-Derbo wrote:rear 4door integra seats fit the civic sedan.
yup and read that 4door bottoms and 2Dr teg tops work the best in Hatchies
Posted:
Sun Feb 03, 2008 7:29 amby perez_tamayo
hahaha i already have eg9 seats for mine.
i want to do something different with dash and door panels though.
Posted:
Sun Feb 03, 2008 8:03 amby perez_tamayo
ok, so i found a write up on fitting the dash and it can be done.
now i need to find out if the door panels fit cause i don't feel like cutting up my stock panels.
http://honda-tech.com/zerothread?id=1211255
Posted:
Sun Feb 03, 2008 9:09 amby ohDirka
Posted:
Sun Feb 03, 2008 9:17 amby perez_tamayo
yeah pretty much the same as the one i found.
the thing is i don't want to cut up the eg door panels just so they fit.
they look like shit.
my brother has a wreck integra, the thing is it's a coupe and i have a eg sedan.
i don't want to buy integra door panels and not be able to make them fit.
Posted:
Sun Feb 03, 2008 10:25 amby perez_tamayo
i found a coupe with dash and door panels.
i think i'm just going to go for it and try the sedan panels
http://www.clubcivic.com/board/showthread.php?t=91189&highlight=integra+door+panels+civic
Posted:
Sat Feb 09, 2008 1:13 amby XocruncheyriceoX
perez_tamayo wrote:i found a coupe with dash and door panels.
i think i'm just going to go for it and try the sedan panels
http://www.clubcivic.com/board/showthread.php?t=91189&highlight=integra+door+panels+civic
You don't have to cut up the civic panels to make the dash fit, you can heat the panels up and then slam the door shut and the civic panels mold to the integra dash and will fit flush w/o any hacking of the civic panels.
Posted:
Tue Mar 04, 2008 9:15 pmby sfixed
yeah but if you do that they will look like shit. Your best bet is to pull th skins of your door panels, after the dash is installed and install door panels line them up make a line were they are going to fit cut panels and have them recovered.
Posted:
Tue Mar 04, 2008 9:16 pmby sfixed
yeah but if you do that they will look like shit. Your best bet is to pull th skins of your door panels, after the dash is installed and install door panels line them up make a line were they are going to fit cut panels and get then have them recoverred.