Civic EG

i've been researching everywhere about this project. looked on h-t, i found the the write up but it doesnt have pics..i have a 2000 integra dash w/ all harness and would love to put it in my eg but is too scared to go through this with out a step by step direction. can anyone point me through an easier path?[/b]

http://www.honda-tech.com/zerothread?id=1211255

I love it lol I want to redue my Cloth on my doors

civic_hatchsi- i've seen this post before. as i was saying there isn't any pics for me to cut and solder the wires. and current project with pics? anyone?

b18c1mien wrote:civic_hatchsi- i've seen this post before. as i was saying there isn't any pics for me to cut and solder the wires. and current project with pics? anyone?

you need a diagram for the wires, should be one somewhere, if your good at wiring it should be pretty straight forward.

Civic_HatchSI wrote:

b18c1mien wrote:civic_hatchsi- i've seen this post before. as i was saying there isn't any pics for me to cut and solder the wires. and current project with pics? anyone?

you need a diagram for the wires, should be one somewhere, if your good at wiring it should be pretty straight forward.

anyone have link?

i found the wire diagram for the 98-01 integra and the 92-95 civic. i'm thinking of using the integra dash harness cause it might be easier. so where/how do i go on from here?

do i just plug the inetgra harness to everything and then with the ends cut/de-pin/re-pin then solder the harness then, plug and play? or it's more harder then that?

anyone know?

Honestly if you don't know which harness to use and don't have some what of a good idea what your doing, I wouldn't attempt this.

hey civic-hatchsi- thanx for all of your help. u have done me a great deed. thanks for saying everything, and showing me everything i asked for. u are the greatest. if u cant help then y post?

Civic_HatchSI wrote:Honestly if you don't know which harness to use and don't have some what of a good idea what your doing, I wouldn't attempt this.

She's right. This isn't a novice project. I've done it a few times and it always takes me way longer than I plan to get all the wiring perfect and to mod the door panels so that everything lines up straight. It's not just a matter of hacking up a few wires and slapping everything in there.

I've also fixed this for a few that people tried and messed up. That takes even longer. It's important to remember that if you mess it up the car may never run correctly again. Or may never run at all.

for the newbs Civic_HatchSI = Female

And if you want the dash swap done you also have to remove the civic steering column support and weld the Integra one in, as it allows the dash to fit much better, but you can also modify the dash if you're scared of cutting your car up


And to be the savior of this thread, i present to you a link with Pics

http://www.honda-tech.com/zerothread?id=285567

i was just saying. my post is pretty much asking for help. why would anyone post something that has nothing to do with help?

but anyways i got it done. wasnt as hard as i thought it would be. gotta small problems here and there but i think i can figure it out. thanx anyways

b18c1mien wrote:i was just saying. my post is pretty much asking for help. why would anyone post something that has nothing to do with help?

but anyways i got it done. wasnt as hard as i thought it would be. gotta small problems here and there but i think i can figure it out. thanx anyways

oh really? you should defiantly do a DIY for those that want to learn and post up pics of your install.