Page 1 of 1
intercooler piping and stock washer bottle?
Posted:
Thu Jun 30, 2011 3:20 amby orangeEG
how do you boosted guys get the piping around the washer bottle?, do you just remove it all together?, if so do you reroute it to a new location or just remove it all together?
Posted:
Thu Jun 30, 2011 1:36 pmby forcefedEG
Mine was long gone when I got my car, so I'm not much help, but I don't see how it would fit in the stock location
Posted:
Thu Jun 30, 2011 2:03 pmby orangeEG
Ya that's what I was thinking, I'm going to try to reroute the bottle somewhere because I would like to keep it haha
Posted:
Thu Jun 30, 2011 2:57 pmby ghskid06
you could get a plastic welder (they are actually fairly cheap). And downsize your container where needed. For instance, cut a corner and then flip it around and replace it so that it makes a notch.
Posted:
Thu Jun 30, 2011 3:18 pmby orangeEG
I think I'm just going to use something similar to a catch can, just a small container and run the pump on the side
Posted:
Thu Jun 30, 2011 6:20 pmby JUICE
i just make sure to clean the windshield when i hit the gas station
Posted:
Wed Jul 06, 2011 3:00 amby flyinryan122
Why is leaving it in the stock location a problem? My piping had no issues with the washer fluid bottle in it's stock placement.