code 43

D15, D16, D17 and Mini-Me swaps
 Reply

code 43

By jordy478
- Tue Jan 12, 2010 10:15 pm #167960 i know this is a fuel systems code....what all do i need to check? i replaced the fuel filter....was else would i need to check fuel pump?

By jordy478
- Tue Jan 12, 2010 10:55 pm #167968 it barely wants to start...like i cranks up the cuts right off and after few times of this if i can catch the gas pedal at the right time it will stay running....but runs ruff....i also got a code 4 which is crank shaft position sensor...
User avatar

By teal_dx
- Wed Jan 13, 2010 12:45 am #167986 crank shaft position sensor is in the Distributor.
See if you can borrow a distributor from a friend and try it on your engine.
Remember to unhook the battery for 10-15 mins to clear the codes. Or there's the ECU fuse you can pull, but I forget which one/color it is. I think it's red 10A in the underhood fuse box :?
User avatar

By eg84dr
- Wed Jan 13, 2010 2:10 am #168006
teal_dx wrote: I think it's red 10A in the underhood fuse box :?

7.5 "back up light" under the hood
that way you dont have to wait ten or fifteen to drive your car

By jordy478
- Wed Jan 13, 2010 1:04 pm #168089 ok will do...and hell ion have nothing but time so waiting cant hurt me to much lol.....one question where is the fuse for the fuel pump at under hood or dash..and wat color and amps?
User avatar

By elrompetoto
- Wed Jan 13, 2010 3:12 pm #168112 Just disconnect the ecu just take the 3 pugs out and put them back in it will re set the ecu I went thure 6 fucking tempeture sensers I kept pulling out the fuse and that shit never re set I disconnected the ecu and bam no more code 6
 Reply
Return to D Series