Civic-EG.com Forum 3.3.1

- Thu Jan 21, 2010 7:00 am #169976 hey guys will a d16z6 head fit on a D15A3 block ? if so is there anything specail that needs to be done?

no rest for the wicked"

- Thu Jan 21, 2010 7:21 am #169982 good Q



thats a old block. it may be different than the newer years' D engines, like the old prelude "B" that is not compatible to the newer B's. could be wrong about that block though.


a kid down the street from me has a clean 86/87 Si (that engine stock) but not sure what all he has done to it.

600whp Turbo 84mm LS/Vtec Drag Hatch

- Thu Jan 21, 2010 1:11 pm #170020 from what iv researched head gasket and oil passages line up but the coolant passges will have to be drilled out a little to line up. 1 head stud hole will have to be machined over (3mm) and a guide pin will have to have the same done (2mm). the head stud hole may cut through the exhuast passges.

- Fri Jan 22, 2010 1:33 am #170185 Thanks for the info . My buddy was finding mixed awnsers everywhere

no rest for the wicked"