Page 1 of 1
help me to find where go the hose
Posted:
Mon Jun 29, 2009 10:47 pmby nicecube
Hello
Its my first post here, i just find ur web site
I have do a swap, a d16y7 into my 93 civic hb si, But i have a little probleme, i dont know where go the other side of the hose
(my english is not very good, sry i speak french i do my best ...)
I hope you can help me
Posted:
Mon Jun 29, 2009 10:49 pmby Ajax1989
holy rust
but is it a coolent hose or a vaccum hose?
Posted:
Mon Jun 29, 2009 11:21 pmby nicecube
I think prestone pass in this hose
When i start the engine i wait 1-2 min after prestone leak to this hole
I dont know where go this hose i have do the swap last summer i dont remember where go the hose
remember my english is not very good lol
i do my best
Posted:
Tue Jun 30, 2009 12:08 amby ThisEarl
I have a hose in the same place that isnt hooked up either, I dont know where is goes, it has a clamp so it did come off something.
Posted:
Tue Jun 30, 2009 12:10 amby teal_dx
did you check to see that the coolant lines are running to the throttle body and IACV sensor (back of manifold)?
Posted:
Tue Jun 30, 2009 12:16 amby ThisEarl
Mine seems to be a vaccum line of some type, as in, its sucking air....
Its been like that since I bought the car 20k miles ago and doesnt seem to matter but I would like to fix it.
Posted:
Tue Jun 30, 2009 12:58 amby pedroa06
yeah u mite want to check that.. i looked at mine and it seems to hide behinda the intake manifold its either a coolant hose or vacumm hose..
Posted:
Tue Jun 30, 2009 4:08 amby eg_turbo_hatch
it looks like the one that hooks to the intake tube an the valve cover
Posted:
Tue Jun 30, 2009 1:27 pmby teal_dx
he says it is a coolant line above. If it was a vacuum line, just put a cap on it. But it is a coolant line so it's not that easy.
Posted:
Tue Jun 30, 2009 1:54 pmby nicecube
im not happy to said : last years i have try to put a bolt in the hose but after 10 min Powww the bolt explose out off the hose lol
Now i have to find where go the extrimity off the hose
Posted:
Tue Jun 30, 2009 2:35 pmby d-mon
it goes to the bottom of the throttle body.
but i can't see if yours has a nipple for it from that angle.
Posted:
Tue Jun 30, 2009 2:44 pmby Classiccarsrule85
If i help you can i get your valve cover lol
Anyhow look at the back of your block there should be a coolant tube black with some rust most likely unless painted....this should have 2 posts comming off with hoses going towards the intake manifold. 1 goes to the back Iac valve the other a bottom nub near where your arrow is....now from the Iac a line should run to your tb and a line from your tb should run to that nub where your arrow is pointing
hope that helps