Civic EG

Well in june when i graduate high school i get some money, like 1200 or something around there. I have no where near enough money to do a engine swap and i'm perfectly content with the power and stuff of my z6.
so the question is, around how much could i rebuild my engine for?
i looked on ebay for a z6 rebuild kit but i dont want to rebuild my engine on ebay parts, so does anyone know of any good sites for a rebuild kit or do i have to go and buy everything peice by peice, how much about will this cost me?

its just a idea, i know i want to do something positive with the money instead of blowing it like a 18 year old kid usually would do.

When you say rebuild... do you mean simply replace piston rings and gaskets/seals and bearings? Or do you mean aftermarket rods & pistons, build the motor to make/handle more power?

What's wrong with your z6 right now that it needs to be rebuilt? (burning oil, knocking etc...)

nope, im not building it to boost or anything
nothing is really wrong with it, it burns a little bit of oil. its just got 171k on it and i figure since im going to college and wont have money to build a engine on the side and stuff, if i could just rebuild mine so it has 0 miles i wont have to worry about a car for college and stuff, it is more of a option. if i can do it cheap i will for reliability.

well i can offer somepriceing advice lol since ive been here and wanted that before....

Dont know about machine work but that ends up getting costly depending where you go there are some shops around us but i never really got far into my build to call and geta qoute or anything....gaskets i know will be quite a bit probaly around 100-200 for everything tho if i can find this place where i got most of my parts it will cost a bit less.....then theres always the opil pump which is around 100+ new i have one laying around thats for the z6 thats newjust the studs for the sump are stripped outs it.....ummm water pump timing belt ofcoarse.....

Now for the fun part a head rebuild would be if you knew the right people to put the head back together at least would be about 100 or so i think if i can get my friend who helped my with mine on board hed port and polish your head aswell for some extra cash which would help nicely....now head internals those youll have to price out as well as block internalsbut as it stands with what i mentioned be ready to just shovel out 500+ just for that stuff maybe a bit less but yea if you do some work yourself then prices can go down ......and if yolur planning on turbo set aside cash for a good tune as well as turbo stuff....id just suggest doing a mild high compression build but its up to you. also i may have some z6 arp headstuds that may interest you lol ......

like i was saying to teal, john im not trying to rebuild it for boost, its just so once college and shit hits im not stuck worrying about my engine with 170k on it.

im not trying to build a race car engine, or some 300 hp one either, i want it how it came from honda, nothing more. im fine with how it acts as it is right now

ohhh ok then well that isnt bad at all tho you still may go over your 1200 budget

and for about 700 you can have yourself a jdm z6 a zc=less work

since its d series i can just use my tranny and stuff right?

yepperz the sohc zc is just a jdm z6 or something like that same ecu can be used etc....

well this is probably OLD post but......TO awnser your question yes with 1200 $ you can rebuild your motor in not sure about the whole rebuild kit site...

http://www.perfectengine.com/Honda_1_6L ... k1221a.htm

where you can aquire all you rebuild parts...if i where you i would go with P29 pistons just to add some more power and good after market rods would be nice to add to rebuild....sorta all motor but reliable for SCHOOL