Civic EG

Ok I was wondering if a d16 intake manif would fit on my d15? would I gain more horse power?>> the reason being is that someone is selling me a skunk2 d16 manifold for 150 and not sure to buy it or not... i would appretiate if some one respond to me .

A Skunk2 Intake Mani will be better then your stock intake.

All 88-00 D Series Intake Manifolds are exchangeable.

If your planning on staying with a D Series for a long time to come then it would be a good idea. Especially if a Minime is in your future.

However if you plan on swapping in anouther Series of engine. Then it would make more since to keep saving up for your swap.

on a side note, the d15b8 head isn't compatible with any other intake manifold, I'm pretty sure the vx model isn't either.

Apexracing wrote:on a side note, the d15b8 head isn't compatible with any other intake manifold, I'm pretty sure the vx model isn't either.

not too sure about that....

All D series 88-00 have the same IM bolts. D15b8 and D15z1 have some of the most restrictive smallest IM's though, so you wouldn't want to put one on your D.

i know for a fact the d15b8 is different from the d15b7 the water port on the head is on opposite sides, ill post up some pics in a few.

edit here are some links to autozone.com, intake manifold gaskets.

d15b8, notice the water port is on the right in this pic.
http://www.autozone.com/autozone/catalo ... ame=Felpro

d15b7,z6 or any other 16 valve engine. notice the water port is on the left.

http://www.autozone.com/autozone/catalo ... ame=Felpro

I think they flipped the gaskets over the opposite way for one of the pics

edit: http://www.hondaautomotiveparts.com/aut ... E+MANIFOLD

have never known www.hondaautomotiveparts.com to be wrong

thats a possibility, but they both require different gaskets so idk.