d15b vtec head mill and deck mill
Posted: Mon Jan 25, 2010 5:57 amI wanted to know if I would be able to mill my head .025 mm and would the result be higher compression??
Civic EG
Forum for the Honda Civic EG 1992-1995
http://www.civic-eg.com/forum/
d15b vtec head mill and deck mill
Page 1 of 1
Posted: Mon Jan 25, 2010 5:57 amPosted: Mon Jan 25, 2010 6:01 amif it hasn't been done already then yes, and your compression would go from 9.14:1 to 9.16:1 Assuming you have a stock engine.
Posted: Mon Jan 25, 2010 6:05 amwat about .040 mm ?? 
with adjustable cam gear and deck about .020 mm ?
with adjustable cam gear and deck about .020 mm ?Posted: Mon Jan 25, 2010 6:58 amd series compression calculator
IT calculates your compression, you will need to convert your .025mm and .040mm to inches, Google will convert it when you type in .025mm to inches
IT calculates your compression, you will need to convert your .025mm and .040mm to inches, Google will convert it when you type in .025mm to inches
Posted: Mon Jan 25, 2010 4:09 pmz6/d15b vtec head can go -.06 with a big cam with p28 or p08 piston.
any farther and you will most likely need deeper valve reliefs, depending on your cam.
vtec heads are a pain to 'clay'
any farther and you will most likely need deeper valve reliefs, depending on your cam.
vtec heads are a pain to 'clay'
Posted: Mon Jan 25, 2010 5:50 pmyea ok well I wanna try to get a lil more compression do I have to put in a bigger cam or could i just do a mild mill ?
Posted: Tue Jan 26, 2010 3:56 ama cam will not affect your compression.
but it can open your valves more, bringing them closer to the piston.
but it can open your valves more, bringing them closer to the piston.