Page 1 of 1

d16a6 a1 pistons y8 head

PostPosted: Sat Mar 13, 2010 8:58 am
by jerez.com
how much horsepower can make this set up
d16a6 block and crank
d16a1 dome pistons and rods
d16y8 head
y8 intake
i have all the parts for this set up any advice i dont have too much money to spend on after market parts
im using acl racing bearings and rings
thanks for the help

PostPosted: Sun Mar 14, 2010 2:13 am
by jerez.com
anyone

PostPosted: Sun Mar 14, 2010 2:13 am
by jerez.com
double post

PostPosted: Sun Mar 14, 2010 2:36 am
by 99cx
dyno?

PostPosted: Mon Mar 15, 2010 1:09 am
by jerez.com
you know a good one in las vegas area

PostPosted: Mon Mar 15, 2010 1:19 am
by eg84dr
heres a tunning place in vegas
not sure on hp but that setup will be about 12.2 to 1 for compression ratio wich means you are gonna need a serious tune
http://www.hondoctors.com/

PostPosted: Tue Mar 16, 2010 3:07 pm
by forcefedEG
most sohc turbo setups with stock internals max at like 220 to 250whp... so i cant really see a Na setup with stock parts going much past like 150 to 180 whp... but i could be wrong... wouldnt mind to see dyno numbers :thumb:

Re: d16a6 a1 pistons y8 head

PostPosted: Tue Mar 16, 2010 3:28 pm
by DavidCivicSi
jerez.com wrote:how much horsepower can make this set up
d16a6 block and crank
d16a1 dome pistons and rods
d16y8 head
y8 intake
i have all the parts for this set up any advice i dont have too much money to spend on after market parts
im using acl racing bearings and rings
thanks for the help


The compression ratio will be somewhere in : 12:1. (if u use Y8-Z6 head gasket)

for power u need a dyno...

PostPosted: Wed Mar 17, 2010 1:10 am
by eg84dr
i wouldnt expect more than 150 wheel horse power
thats what im aiming for with my build

PostPosted: Wed Mar 17, 2010 2:43 am
by jerez.com
i think my c/r is 12:61.1 but anyways almos done whit the proyect as soon i have the car runing i go to dyno and post how works
here is a pic is not too god is from my phone
Image

PostPosted: Sat Mar 20, 2010 7:58 am
by jerez.com
i got the car working today runs fine and stong any body in vegas that know tuning place besides hondoctors is cain expencive for me