d15b head skimming
Posted: Fri Apr 30, 2010 12:16 pmIm undecided whether to get the head skimmed on my d15b. I will be using a d16y8 headgasket. What is a sensible amount to take off the head? Or is there no real point in having it done?
Page 1 of 1
Posted: Fri Apr 30, 2010 12:16 pmPosted: Fri Apr 30, 2010 1:14 pmThe only reason to get it done is if the head is warped or if you are trying to raise compression ratio.
Posted: Fri Apr 30, 2010 1:31 pmteal_dx wrote:The only reason to get it done is if the head is warped or if you are trying to raise compression ratio.
x2, but imo, there are better ways to raise your compression than that, as you can sometimes loose a tooth of timing if you take too much, ive allways been told to take the least amount possible
Posted: Fri Apr 30, 2010 3:24 pmOk cheers i think i will give it a miss. Unless i discover the head is warped when i take it off.