Page 1 of 1
D15b8 help please
Posted:
Sat Jun 05, 2010 7:20 amby 92egdxhatch
Yes I'm aware this motor sucks. I've searched but can't find what I'm lookking for. I've obtained a freshly rebuilt b8 bottom end, and an a6 head. The b8 has pm3 pistons. So I know the a6 head will work. My question is what is needed to make the obd-0 head work with my obd-1 car? Can I just use b7 dizzy? Intake mani? Or would it be easier just to use my b7 head with the a6 cam?
Any information, tips, are needed and welcome. Thanks in advance, Andrew.
Posted:
Sat Jun 05, 2010 9:02 pmby 92egdxhatch
A6 head needs rebuilt for sure so I'm gonna use my b7 head is the a6 cam a direct swap?
Posted:
Sat Jun 05, 2010 10:24 pmby teal_dx
I have never done it, but have read it is. The only thing I would check out is the cam gear... to find out which one you need to keep timing from being off 1/2 a tooth.
Posted:
Sat Jun 05, 2010 11:41 pmby 92egdxhatch
I have an ajustable cam gear for d-series if that will work.
Posted:
Mon Jun 07, 2010 4:53 pmby d-mon
you can use a y7/y8 cam gear, or your adjustable gear (advanced 4.x* or 1/2 tooth)
Posted:
Mon Jun 07, 2010 6:37 pmby 92egdxhatch
Can I just take the a6 cam right out and put it in my b7 without needing anything new?
Posted:
Tue Jun 08, 2010 12:14 amby AutoXCivic
92egdxhatch wrote:Can I just take the a6 cam right out and put it in my b7 without needing anything new?
Yes.
Posted:
Tue Jun 08, 2010 3:10 pmby d-mon
AutoXCivic wrote:92egdxhatch wrote:Can I just take the a6 cam right out and put it in my b7 without needing anything new?
Yes.
with the cam gears i mentioned