Civic-EG.com Forum 3.3.1

- Sun Nov 14, 2010 7:17 pm #222893 When installing a Z6 head onto the 15b7, which head gasket should I use?

- Sun Nov 14, 2010 10:03 pm #222906 Either a z6 or a d16y8. The y8 will yeild a slightly higher compression ratio

D16z6. Golden Eagle. AFI Turbo. Precision Turbo. Hondata. CG racing.
618hp, 407tq SOHC 10.68@137
My 92 hatch SOHC build. Quest for +600hp. Check it!

- Sun Nov 14, 2010 10:20 pm #222908 or more thiner head gasket 0.030", cometic or something like that, to raise compression ratio more, it's thiner then stock d16y8/z6

- Mon Nov 15, 2010 1:00 am #222922 Swapping to the z6 head with a z6 gasket already nets you 10+:1 CR. Just use the z6 head gasket if you want to bump the CR a bit, have the head milled while it's off the block.

Straight lines are for sissies.