Civic EG

Posted: **Mon Mar 14, 2011 10:38 am**

i got a bare z6 intake mani and want to know what i need to bolt it up to my 95 b7

Posted: **Mon Mar 14, 2011 1:27 pm**

its a direct swap, just unbolt the d15b7, transfer over the sensors to the d16z6 and bolt it on :thumb:

port-matching will help with better flow but is not essential if you can't do it now.

Posted: **Mon Mar 14, 2011 9:22 pm**

so which gaskets would i use with it for a b7 or a z6 ?

Posted: **Mon Mar 14, 2011 10:58 pm**

kt95CiviCDX wrote:so which gaskets would i use with it for a b7 or a z6 ?

Intake manifold gasket for a Z6

Posted: **Tue Mar 22, 2011 1:05 am**

and for the throttle body would i use the z6 or b7 ? and do i need to use any sealant on the gaskets ?

Posted: **Tue Mar 22, 2011 1:09 am**

either or

there the same

i put a z6 manifold on my b7, using my b7 sensors and throttle body

Posted: **Tue Mar 22, 2011 1:15 am**

i forgot to add that i meant the gasket for the throttle body...and will the b7 injectors fit the z6 injector seals ?

Posted: **Tue Mar 22, 2011 2:21 am**

kt95CiviCDX wrote:i forgot to add that i meant the gasket for the throttle body...and will the b7 injectors fit the z6 injector seals ?

Yep the injectors will fit :thumb:

what all is neededto put a d16z6 intake manifold on to my b7