Civic EG

Posted: **Thu Mar 24, 2011 3:52 pm**

Hi Guys... I purchased a refurb D15B7 cyl head for my 91 civic (non-vtec) ... I need to set the Valve clearance as the head came with the valve clearance bolts loose. Could someone explain how and when to set it... should I place each cyl. at TDC in order to set the clearance for the respective valves ... or is there a 'how to ..." for setting it ...
I have the settings for the Intake Valve lash at .007-.009 cold (.1) ... and the Exhaust Valve lash at .009-.011 cold (.229-.279) .. Thanks

Posted: **Thu Mar 24, 2011 5:24 pm**

If you go to the DIY section of the forum, you will see there is one on that matter. Good luck

Posted: **Thu Mar 24, 2011 10:44 pm**

tatan1106eg wrote:If you go to the DIY section of the forum, you will see there is one on that matter. Good luck

.. thanks.. I'll try it out.

Posted: **Mon Mar 28, 2011 3:18 am**

jmoshe wrote:
tatan1106eg wrote:If you go to the DIY section of the forum, you will see there is one on that matter. Good luck
.. thanks.. I'll try it out.

I finally got the valve rocker clearance set right... The engine fired up right away ... Thanks... you have been very helpful..
but .... I am getting alot of white smoke and for that I will open a new thread...

Civic EG

How to set valve clearance on a D15B7 cyl head

How to set valve clearance on a D15B7 cyl head