Civic EG

I got a question about the swap i'm doing? i'm got a 92 vx hatch and i'm swaping a 95 d16z6 in. I was just wondering if it is as easy as drop the d15 out and drop the d16 in. I already got a p28. Any help is appreciated

its as easy as it sounds

pull the d15 out and put the d16 in and hook up the p28 and start her

pretty much plug and play, but u would need to get a 4 wire O2 sensor for the Z6.

I don't think vx's are prewired for vtec
you might have to wire in vtec which is
vtec oil pressure sensor
vtec selenoid....
right

OleFolk wrote:I don't think vx's are prewired for vtec
you might have to wire in vtec which is
vtec oil pressure sensor
vtec selenoid....
right

the vx is vtec

well vtec-e

94_jdm_ferio wrote:

OleFolk wrote:I don't think vx's are prewired for vtec
you might have to wire in vtec which is
vtec oil pressure sensor
vtec selenoid....
right

the vx is vtec

well vtec-e

x2

Just have to get a EX/Si Wiring harness and an OBD1 p28 ECU. That should take care of the wiring. Otherwise you need to convert your harness from a 5 wire o2 Sensor to a 4 Wire o2 Sensor.

right....well nvm then

OleFolk wrote:I don't think vx's are prewired for vtec
you might have to wire in vtec which is
vtec oil pressure sensor
vtec selenoid....
right

x2

Just have to get a EX/Si Wiring harness and an OBD1 p28 ECU. That should take care of the wiring. Otherwise you need to convert your harness from a 5 wire o2 Sensor to a 4 Wire o2 Sensor.

the vx has the d15z1 which is vtec
the only thing that might need to be wired is the o2 sensor
vtec is already wired

pretty sure thats how it was. thanks guys