Page 1 of 1
water connector pipe replacement? for d15b7
Posted:
Sun Oct 09, 2011 8:44 pmby 603 jdm
so i have the new water connector pipe for my d15b7. and was wondering in anyone had any tricks on how to replace it? and if i need a new housing gasket in order to complete it?
Posted:
Mon Oct 10, 2011 3:51 amby teal_dx
I believe there's an O ring gasket on each end. I've never replaced one with a head or intake manifold on the motor... those things will make it difficult but probably not impossible.
Posted:
Mon Oct 10, 2011 1:49 pmby 603 jdm
i meant to add in i have the intake manifold off already. i ordered have both o ring and the pipe i payed about 35 bucks for them off of bkhondaparts.i think i just have to take the two bolts out that go into the block to hold the housing. im changing the thermostat just to be safe and do preventive maintnence also
Posted:
Mon Oct 10, 2011 5:25 pmby d-mon
there are o-rings on either end. you should replace them both.
Posted:
Tue Oct 11, 2011 1:13 amby 603 jdm
i got the new pipe and o-rings, i also cleaned out the pcv box that sits near it.