3 Stage Vtec ECU Info Needed
Posted:
Tue Dec 27, 2011 3:58 amby anya2dgre
I have d15b 3 stage vtec engine that I purchased from a mechanic. I also got a p2j-j62 ecu with engine harness that I also bought from another guy. I presently have an Eg8 vti with a d15b vtec. Will my harness from my dash be compatible. Is there anything that will not work. Does any one know where I can get a pin out for the P2J-J62 ECU I will really appreciate it.
Posted:
Wed Dec 28, 2011 5:21 amby Classiccarsrule85
check out this site it explains alot and from our fellow civ-eg member suspendedHatch too
and also the p2j ecu is obd2 as is the d15b with 3stage so you will need a jumper harness but anyhow check out the link
http://causeforalarm.thecarthing.com/3- ... index.html
Posted:
Thu Dec 29, 2011 2:10 amby suspendedHatch
As stated, you will need convert to OBD2 and then add wires for EGR and VTEC2. Your ECU will need to match the transmission type. If it's auto then I believe you will need to get a CVT and make a custom mount.
I can't go into any great detail because this isn't the swap I had. I was running a 3 stage VTEC with a JDM 5th gen manual trans and an OBD1 AEM EMS.