Civic EG

I'm in need of a cank. my block says D15B but it has factory vtec, are the main bearing size different? or will the be interchangeable?

not with a d16, shorter stroke and smaller main bearing journals.

I was able to find a guy that specializes in removing broken bolts. so he gonna remove the bolt n fix the threads if nesesary. I'll post the measurements of the main journals and rod journals.

i'v already measured them, 48mm
mains and rod journals are the same size on jdm d15b vtec crank.

here is a close up of the rod and main journals:

ok that is the crank that I have, all the shops said it was a jdm only crank and they didn't have a replacement.

its going to be really hard to find one in good condition.
what is wrong with yours? spun bearing?
even d16 cranks are becoming scarce.

d-mon wrote:its going to be really hard to find one in good condition.
what is wrong with yours? spun bearing?
even d16 cranks are becoming scarce.

i broke the pulley/balancer bolt, but I found a shop that can remove the broken pice n fix the threads.
where do u think I can get replacement bearings from? I threw mine out when they machined my block.

thnx for the help man.

main and thrust for usdm d15b7/8/2, rod bearings for d16.
i like King bearings.
piston rings for obd2 d16y8/7/5.

Thnx man. u pretty much got me covered. should have this thing running in no time.