Page 1 of 1

D15B swap question

PostPosted: Thu Oct 04, 2012 9:32 am
by Diiplomat
I am swapping a JDM D15B into my 93 DX.

My car had a D15B7 automatic

the car is staying automatic...


My question is, What mounts do I use? Can I use B7 mounts? will my power steering pump, AC compressor fit on the JDM engine?

thanks in advance.

Re: D15B swap question

PostPosted: Thu Oct 04, 2012 1:18 pm
by teal_dx
Diiplomat wrote:I am swapping a JDM D15B into my 93 DX.

My car had a D15B7 automatic

the car is staying automatic...


My question is, What mounts do I use? Can I use B7 mounts? will my power steering pump, AC compressor fit on the JDM engine?

thanks in advance.

You can use your old mounts for the rear mount and tranny mount so you can keep your auto tranny. The driver's side mount will be the same on both motors.
When looking at your d15b7, it will have a big old bracket on the front that the PS and AC are bolted to. Just take that entire bracket and the little lower torque mount from your D15b7 and put that on your D15B. (Might actually be easier to put that stuff on after the new motor is in the car)