Civic EG

Ok guys, now i got the old one out as it was a pain in the A. i put the new ones on the valve cover slide it on to the head and i find out it wont go flush with the spark plug hole, i was thinking i may have put it in upside down or the wrong way into the valve cover. does anyone have a picture of the seals how they sit inside the valve cover. its a d16z6

Are you sure they are the correct ones? Did you compare the new ones with the old ones side by side to be sure they are the same?

Actually the old ones were very bad. theres no way to compare them, but it does fit the valve cover with a little tap. it came with the valve cover rubber seal in a kit at auto advance. I took one out and tried it on the spark plug hole and it seems that the inner circle is a little big, but at the same time it fits inside the valve cover

You should have recieved #8
12342-RYE-004

They go with the most surface area towards the cylinder head.

Yes thats the one i got, so it goes in just like the pic right? Cuz if so i had it upside down lol

N thanks guys ill give it another try in the morning, also where are you guys gettingthese diagrams from

http://www.hondaautomotiveparts.com/aut ... Search.jsp

reaperstk wrote:Yes thats the one i got, so it goes in just like the pic right? Cuz if so i had it upside down lol

Yes just like it looks in the picture.