Page 1 of 1
problem with my d13..
Posted:
Sun Jun 30, 2013 8:20 pmby alexwiththeeg3
Hey guys, so today I put a stainless exhaust mani on my d13 single carb, I already had a decat pipe and stainless cat-back, but now I've lost all back pressure and the car is slow as hell :/ my problem is I can't turn the fuel screw on the carb as the engine management puts the fueling back to standard... Has anyone got any ideas if bigger jets would help? If so where would I look and also what size would I get as I don't know what standard ones are..[/quote]
Posted:
Sun Jun 30, 2013 9:44 pmby nd1983
Changing to a SS exhaust manifold shouldn't require an adjustment to the A/F ratio.
did you disconnect anything you didn't reconnect?
do you have an exhaust leak with is causing the lose of back pressure?
have you tried putting it back to the way it was before and see if it runs proper?
Posted:
Sun Jun 30, 2013 10:17 pmby alexwiththeeg3
The reason I think it's losing all the back pressure is because it's a 1.3 and it now has no cat and roughly 2" pipes all through and it's running on a stand a/f ratio
Posted:
Sun Jun 30, 2013 10:32 pmby alexwiththeeg3
Oh and by slow I mean I doubt it could reach 100mph right now
Posted:
Tue Jul 02, 2013 10:56 pmby alexwiththeeg3
Anyone got any suggestions?..