Page 1 of 1
d series build question
Posted:
Tue May 06, 2014 12:56 amby wolfman93
Is a 10.34:1 cr safe with good tune to run 6-8 psi? I'm wanting to use a d15b7 block with p29 zc pistons, d16a6 head, z6 manifold, b18b throttle body, and a 50 trim Garret t3/t4
Posted:
Tue May 06, 2014 1:15 amby teal_dx
What's your HP goal?
That's pushing it to the limit IMO on a D15b7 bottom end with the stock rods. A perfect tune is going to be crucial. What fuel management will you use?
Posted:
Tue May 06, 2014 1:20 amby wolfman93
230-240 whp rrods won't be stock. Forged h beams scat. Chipped and socketed P06 walbro 255 pump DSM blue top 450ccs.
Posted:
Tue May 06, 2014 11:06 amby wolfman93
BTW teal this is going in an EF with si ttransmission and car is being obd1 converted.
Posted:
Wed May 21, 2014 8:23 pmby Virux
Are you using the CX B2 rods? I'd like to know how those are..