Page 1 of 1
getting started
Posted:
Thu Jun 19, 2008 5:09 amby 93cxhb
Ok im new at this and need a little help here i just did a wire tuck on a 93 cx hb with d16z6 and now it won't start turns over though the only thing i know i didn't do is hook up my o2 sensor could this be the problem. any ideas or help is appreciated
Posted:
Thu Jun 19, 2008 5:31 amby chrono404
What happens when you try to start the car?
Things to check:
Power terminals on Battery
Starer Wires, check the small one and make sure its connected.
If that doesn't fix it, post what happens when you try and start the car.
Posted:
Thu Jun 19, 2008 6:34 amby 93cxhb
battery terminals are good. car turns over but won't start there is fuel getting to the fuel rail. im gonna check for spark next im wondering about the o2 sensor. also if there are any other things i can check . thanks
Posted:
Thu Jun 19, 2008 9:05 amby Ecc0
Did you prime the injectors before trying to turn it over??? If not disconnect the Dizzy and give it a few turns to prime them then give it another go.
Other than that try checking the little spade on the starter motor.
Then O2 sensor wont stop the car starting but will bring up an ECU/Engine check light once the car starts.
Posted:
Thu Jun 19, 2008 3:58 pmby a_CoUpE
make sure you pluged in you main ground, and check your main relay.