Page 1 of 1
im lost
Posted:
Tue Sep 23, 2008 12:32 amby Jadori
have put on an intake before..so i got my intake today and i got my throttle body spacer..so i swap out the gasket on the throttle body and put it back on(i didnt put the spacer on) i put my intake on and turn it on and it now idles at 3000..i dont know what happened i checked my lines i even tried adjusting the throttle cable i got nothin...this car has a piece of shit since i got it!!!!!!
Posted:
Tue Sep 23, 2008 12:39 amby 95projektvic
adjust the throttle position sensor.....i'll try and find a picture of it....unless someone and get that before me
Posted:
Tue Sep 23, 2008 12:47 amby Benj
need to clean you idle air control valve ( i think thats what its called ) its located under the t/b has a hose going into it and coming out from the intake and going back into it, there are 2 lil screws that you will have to take off and then adjust the white cap, in or out, till it idles better
Posted:
Tue Sep 23, 2008 2:44 amby suspendedHatch
You didn't clean off the old gasket and/or tighten down the throttle body correctly and evenly. Or you didn't install the new gasket properly.
Posted:
Tue Sep 23, 2008 2:46 amby teal_dx
did you check to see if your throttle plate is closing completely? if not, adjust the throttle cable by giving it a little slack.
Posted:
Tue Sep 23, 2008 2:54 amby Jadori
ill try all that..ive cleaned my iacv about 2 weeks ago..but ill do it again
Posted:
Thu Sep 25, 2008 7:25 amby Jadori
ok i went through all that and the solution was the gasket..the hole on the gaskets that came with the spacer were way bigger than the oem gasket..that sucked..i hate spacers!
...lol
Posted:
Thu Sep 25, 2008 1:17 pmby 95projektvic
glad it worked out for you.
Posted:
Thu Sep 25, 2008 2:37 pmby Jadori
thanks me too