cam question
Posted: Wed Mar 04, 2009 4:56 amso i was wondering if ther are any more aggresive cams i can put in my stock d15b7 from another stock d series motor
Page 1 of 1
Posted: Wed Mar 04, 2009 4:56 amPosted: Wed Mar 04, 2009 4:11 pmget a cam from a d16a6 its the more aggressive stock D series cam that will work well in your car.
Posted: Wed Mar 04, 2009 7:38 pmwell i though that was a vtec cam so i didnt think u could use it myabe im off if i did use it would i use the stock cam gear or the one from the a6?
Posted: Wed Mar 04, 2009 9:03 pmd16A6 is not vtec.
the A6 head is from the same casting as B7 head.
use a Y7/Y8 cam gear or adjustable cam gear to compensate for the deck height difference between d15 and d16.(one tooth difference, 4.x*)
and while your at it add, a Z6 intake manifold.
it will run well with your p06 ecu and make noticably more power
the A6 head is from the same casting as B7 head.
use a Y7/Y8 cam gear or adjustable cam gear to compensate for the deck height difference between d15 and d16.(one tooth difference, 4.x*)
and while your at it add, a Z6 intake manifold.
it will run well with your p06 ecu and make noticably more power
Posted: Wed Mar 04, 2009 9:33 pmreally, noticeable power from doing that?
Posted: Thu Mar 05, 2009 6:06 amhatchin06 wrote:really, noticeable power from doing that?
noticable, yes. along with i/h/e.
more noticable was swapping the dx for an ex transmission, though.
Posted: Sat Mar 07, 2009 11:00 amwhat about a d16z6 cam swap any out for that??