Civic-EG.com Forum 3.3.1

- Mon Sep 20, 2010 1:31 pm #214581 hi i have a b20vtec, its on a automatic tranny. i bought a Hondata S300 but my tuner told me to hold up on putting it in and doin the tune,
until i get a manual gear box, cuz the auto wont shif properly after the tune.
im currently using the stock b16a ECU "OBD1" on the b20, my tuner said i could use that for the while but i have to get a FPR so my question is what pressure to set it to?..im thinking bout 45 - 48 psi all the parts are stock by the way.
any info will be appreciated.

"If you have poo, fling it now"!.

- Mon Sep 20, 2010 9:00 pm #214654 I personally would never run a b20/vtec on a b16a ecu. To many differences in the motors. Do the manual swap, get it tuned and do drive it until then.

You could damage the motor.

1986 Nissan 300zx
1980 Kawasaki KZ650
2014 Kawasaki Ninja 300