Civic-EG.com Forum 3.3.1

- Fri Mar 07, 2008 5:53 pm #45391 guys, what's the best solution to aviod the conrod bearing from ware off.... i've seeing this problem many times... ... the bearings are not durable and only last for few drag race events. Even using Acl Racing series bearings, sooner or later damage will occur due to the friction. Hope we can exchange some info and opinion here... thanks...

Last edited by cukakula on Fri Mar 07, 2008 6:34 pm, edited 4 times in total.

[chrono404]

- Fri Mar 07, 2008 5:57 pm #45392 http://civic-eg.com/viewtopic.php?t=2027

That goes into great depth on howto make a Reliable B20vtec or an LSvtec.
I was planning on going B20vtec, However after reading many things about them. I will just make an LSvtec, Then Boost it to get the extra torque.

2017 Chevy BoltEV DD |2001 Honda CRV SE

- Fri Mar 07, 2008 6:08 pm #45393 yup, i've gone thru the article.... Hmmmm wonder how much is going to cost???? any ideas???