B16a In CRX Si

B16, B18, B20
 Reply
User avatar

B16a In CRX Si

By Dippin_EG
- Fri Jul 25, 2008 3:24 am #63314 This question is a little off topic, but i am yet to find a definite answer. I am swapping a JDM b16a into a CRX Si (91), and i need to know if i am to use the fuel rail and injectors, clips and distributor drom the D16 i took out of it. The OBD0 D15 Injector clips dont fit on the B16 and i have heard to use the Si's stuff but never got a definite answer. Any help would be much appreciated
User avatar

By Benj
- Fri Jul 25, 2008 6:30 am #63327 you have to use the si clips and harness, you sould also use the b16 injectors, for flow. now i have heard a few people say that all honda injectors are the same but i am not sure, i also know that you have to use the ecu for that enine to run vtec, so you have to go on ebay and buy a jumper harness or build one and then you also have to pin ( wire) in the vtec solenoid, question for you what the motor out of???
User avatar

By Dippin_EG
- Sun Jul 27, 2008 4:35 pm #63500 Problem solved.... so far
 Reply
Return to B Series