Page 1 of 1
b18c engine, EG4, standard brakes and hubs..
Posted:
Fri Jun 26, 2009 1:07 pmby Kane
Question ...
is it possible to use my original brakes from my EG
4x100
on my B18c? will the shaft fit etc?
cheers
Posted:
Fri Jun 26, 2009 11:26 pmby Greasedmonkey
If you are talking about just swappin the motor into your eg4 and asking if everything will work, then yes. It all bolts on just fine. you can use your stock brakes.
Posted:
Tue Jun 30, 2009 2:15 amby courtottman
yeah he's right, but if youre running the driveshaft aswell i think it may be a 4x114.3, i had this same problem although myne was a jdm b18cr, just measure the stud pattern and look....
Posted:
Sat Jul 04, 2009 12:51 amby Greasedmonkey
courtottman wrote:yeah he's right, but if youre running the driveshaft aswell i think it may be a 4x114.3, i had this same problem although myne was a jdm b18cr, just measure the stud pattern and look....
Your talking about the 96 ITR brake swap. They had 4x114.3 he isnt asking if that will work at all. he just wants to know if he can use his stock brakes with the motor swap.