Civic EG

Ok guys i just picked up my new motor yesterday its a obd 2 gsr with a b16 type r head on it. it have no dizzy on it would i be able to use a obd1 b16 dizzy on it or do i need an obd2 dizzy for it pics will be up sooon

both will bolt up fine, but you will need an adapter to run an obd2 dist if your using an obd1 engine harness...

http://www.jegs.com/i/MSD+Ignition/121/8864/10551/-1 <- like this one

personally id just get an obd1 dist if you can get your hands on one cheap, if you get a good price on a obd2 and the harness isnt that much more, go that route.... there is no performance difference between the two...

is that all i will need also i got the car with no fuel injectors can i use the ones out of my ls. also is there any thing else that i need obd1 to make it run

yea all the injectors odb1 and 2 were the same size with the exception of the h and f series... and obd1 and 2 having diff. clips... assuming a distributor is all you need, than yes you should be fine...