Page 1 of 1
B16 swap ?
Posted:
Sun Sep 02, 2007 12:06 pmby sqsi
I have tried to do a search on this but have not found anything yet. I have a 92 Si and want to swap the D16Z6 for a B16a2. since this engine was available in an EG can I buy just the engine, or will I need axles, mounts, Transmission, ECU, ECT.
Thanks in advance
Posted:
Sun Sep 02, 2007 1:26 pmby ChicagoMike
You need all the above.
Posted:
Sun Sep 02, 2007 2:42 pmby sqsi
Thanks, That figures. Well at least I know what I am in for now
Posted:
Sun Sep 02, 2007 6:29 pmby Greasedmonkey
its not as hard as you might think.
Posted:
Sun Sep 02, 2007 8:35 pmby sqsi
I was just hoping to saving a few bucks, thats all. no big deal
Posted:
Mon Sep 03, 2007 4:32 pmby Civic_HatchSI
yea u will need
axles
shift linkage
motor mounts
ecu
tranny
but you wont have to wire up the vtec sence your hatch is a 92 si its already there for you
Posted:
Mon Sep 03, 2007 8:05 pmby chnzgoofball
JDM-Chick wrote:yea u will need
axles
shift linkage
motor mounts
ecu
tranny
but you wont have to wire up the vtec sence your hatch is a 92 si its already there for you
yup but i would suggest u to change the water pump and check the clutch while its out (thats if u dunno the history of the motor)
Posted:
Mon Sep 03, 2007 9:42 pmby Civic_HatchSI
^^^ yep yep
and timing belt lol
Posted:
Mon Sep 03, 2007 10:48 pmby Greasedmonkey
Timing belt, water pump, oil pump and your basic tune up should all be done before you put it in.
Posted:
Tue Sep 04, 2007 2:00 amby sqsi
Cool, Thanks for the responses.